****OG SIGNAL ISOLATOR GRAVITY

The ****og Signal Isolator can isolate ****og signal and provide isolated power to sensors. It can effectively prevent sensor signal interference and apply to multi-parameter water quality monitoring sensors. Because usually sensors will be interfered by the other sensors during the measurement, especially those sensors in water quality monitoring system. For example, pH sensor (pH meter) will be affected by the electrical conductivity sensor (EC meter).
The common solution is to isolate the power supply. Once you put them into the same container and share the same power supply, their value won’t be interfered by each other.This ****og signal isolator is designed for this situation, it will isolate the ****og signal and provide isolated power to the sensors. It has an on-board 5V isolated power IC, and compatible with Gravity-3Pin interface, plug and play, no need for soldering. The transform rate is 1:1, which means ****og values in two sides should remain the same.

SPECIFICATION
- Operating Voltage: 5.0V
- Response Time: 4 seconds (Typ)
- ****og Error (both ends):
- Interface Type: PH2.0-3P
- No load Current: 75mA
- Dimension: 42 * 32mm / 1.65 * 1.26 inch
- Non-isolated Terminal (Arduino Side)
- Supply Voltage: 5.0 ± 0.1V
- ****og Output: 0 ~ 5.0V
- Isolated Terminal (Sensor Side)
- Output Voltage: 5.0 ± 0.2V
- ****og Input: 0 ~ 5.0V