09055753988
Paranaque
PH Meter Sensor ****og Kit (Arduino Compatible)
We are one of the largest free online selling communities with thousands of active sellers.
Do you have something to sell? Your next sale might be just a few clicks away.
Based from 899 member feedbacks. We value your suggestions and use it.
You may now measure water quality and other parameters affordably. It also Arduino Compatible, -- especially designed for Arduino controllers to easily interface the sensor with practical connector. This will enable to extend your project to bio-robotics. It has an LED which works as the Power Indicator, a BNC connector and PH2.0 sensor interface. To use it, just connect the pH sensor with BND connector, and plug the PH2.0 interface into the ****og input port of any Arduino controller. If pre-programmed, you will get the pH value easily.
SPECIFICATION
- Module Power : 5.00V
- Module Size : 43 x 32mm
- Measuring Range :0 - 14PH
- Measuring Temperature: 0 - 60 ?
- Accuracy : ± 0.1pH (25 ?)
- Response Time : ? 1min
- pH Sensor with BNC Connector
- pH2.0 Interface ( 3 foot patch )
- Gain Adjustment Potentiometer
- Power Indicator LED
This seller has been a member since: Feb. 11, 2017
Member Location:
Total Classifieds: 1345
Why seller feedback is important?
Transact with most credible & reputable sellers
Know the seller you are going to deal with
Claim warranty long after purchasing the item
Warn you and other buyers against scams
Motivates sellers to provide good service