TIME OF FLIGHT LIDAR SENSOR

Measure range out to 200cm with high accuracy independent of reflectivity!

What is it?

This is a small (18 x 8 mm) breakout board for ST Microelectronics' latest VL53L0X proximity sensor. The sensor is the successor to the VL6180X ******t light and proximity sensor. The VL53L0X offers ranging only, but extends the range of accurate distance detection out to 2 meters. And because the patented ranging technology uses time-of-flight from a 940 nm laser, the range estimation is independent of surface reflectivity. This means higher accuracy in any weather or environmental conditions compared to ranging technologies that depend on changing reflectance to estimate range.

From the data sheet: "The VL53L0X is a new generation Time-of-Flight (ToF) laser-ranging module housed in the smallest package on the market today, providing accurate distance measurement whatever the target reflectances unlike conventional technologies. It can measure absolute distances up to 2m, setting a new benchmark in ranging performance levels, opening the door to various new applications.

The VL53L0X integrates a leading-edge SPAD array (Single Photon Avalanche Diodes) and embeds ST’s second generation FlightSenseTM patented technology. The VL53L0X’s 940nm VCSEL emitter (Vertical Cavity Surface-Emitting Laser), is totally invisible to the human eye, coupled with internal physical infrared filters, it enables longer ranging distance, higher immunity to ******t light and better robustness to cover-glass optical cross-talk."

Here the VL53L0X is broken out onto a super small board intended to be mounted directly onto an MCU like a Teensy 3.2 or Dragonfly. Because the VL53L0X is such a low power sensor, it can be powered from 3.3 V via a digitalWrite(HIGH) from any digital GPIO. Or use it on the breadboard, but 3.3 V only; the VL53L0X is not 5 V tolerant!

Unlike the VL6180X, the VL53L0X input voltage range spans from 2.6 to 3.5 v, so standard 3.3 V sources can be used to power the sensor without the on-board 2.8 V LDO voltage regulator that is required for the VL6180X sensor. Hence, the price of the VL53L0X breakout board is a little less than that of the VL6180X. Of course, there is no ******t light sensor embedded in the VL53L0X either.

Lastly, the VL53L0X comes with a protective Kapton film that should be gently removed with non-metallic tweezers before being put into your application.

Why did you make it?

I like sensors, new and small and I can't resist trying out the latest and greatest.

But there is a practical reason as well. For flying or rolling robots there is a real need for small, accurate proximity sensing for collision avoidance, near-field object range detection, gesture recognition, and altitude hold. At 2 meters, the VL53L0x opens a wide range (pun intended) of applications in a super small, low-power package that can easily be incorporated into very small robots.

What makes it special?

This breakout board is small and simple to use. It breaks out SDA/SCL, 3V3 and GND, an active LOW shutdown pin (pulled HIGH) and an interrupt for the host. It has everything you need to incorporate this sensor in your project or on the breadboard for testing and application code development.