FINGERPRINT SCANNER GT-511C11

Fingerprint Scanner GT-511C11 5V TTL
This fingerprint scanner GT-511C11 from ADH-Tech communicates over TTL Serial so you can easily embed it into your next project. The GT-511C11 is exactly the same in features with the GT-511C1R, it only differs in its physical form factor.

The module itself does all of the heavy lifting behind reading and identifying the fingerprints with an on-board optical sensor and 32-bit CPU. All you need to do is send it simple commands. To get started, just register each fingerprint that you want to store by sending the corresponding command and pressing your finger against the reader three times. The fingerprint scanner can store different fingerprints and the database of prints can even be downloaded from the unit and distributed to other modules. As well as the fingerprint “template,” the ****yzed version of the print, you can also retrieve the image of a fingerprint and even pull raw images from the optical sensor!

The module can store up to 20 different fingerprints and is capable of 360° recognition. If you need more fingerprints you can check out GT511C3.

The module is small and easy to mount, using two mounting tabs on the side of the sensor. The on-board JST-SH connector has four signals: Tx, Rx Vcc, GND. Demo software for PC is available in the documents below, simply connect the module to your computer using an FTDI Breakout and start the software to read fingerprints!

Includes: JST-SH Connector

Dimensions: 37 x 17 x 9.5 mm

Features:

High-Speed, High-Accuracy Fingerprint Identification using the SmackFinger 3.0 Algorithm
Download Fingerprint Images from the Device
Read and Write Fingerprint Templates and Databases
Simple UART protocol (Default 9600 baud)
Capable of 1:1 Verification and 1:N Identification
360° Fingerprint Recognition