L298N H-BRIDGE STEPPER/DUAL DC MOTOR DRIVER MODULE

MODULE
Think it... Make it... Invent!

This module, you can use the built-in 78M05 take power by driving the power section, but in order to avoid damage to the regulator chip, when use is greater than the drive voltage of 12V, use an external 5V logic supply.

L298N is a high voltage, high current motor driver chip. Having a 15-pin package, this chip has such features as high working voltage(maximum voltage up to 46V),large output current(instantaneous peak current up to 3A,continuous working current 2A) and 25W of rated power. Two built-in H bridge high voltage and large current full bridge drivers can be used to drive two DC motor and a stepper motor, relay coil and so on. Using standard logic level signal control,it has two enable control ends. It permits or prohibites device having a logic power supply input without the impact of input signal,which enables the internal logic circuit part works at low voltage. The chip can connect to external detecting resistor to give the variations to the control circuit. This chip can drive a stepping motor or four phase stepping motor,and two DC motors as well.

Module name:Dual H-bridge motor driver module
Operating mode: H-bridge driver (dual)
Master chip:The L298N (ST new original)
Logic voltage:5V
Drive voltage:5V-35V
Logic Current:0mA-36mA
Drive current:2A (MAX single bridge)
Storage Temperature:-20 ° C to +135 ?

Maximum Power:25W
Weight:30g
External dimensions:43 * 43 * 27mm



Product Features:

This module uses L298N chip as the main driver, driving ability, low heat, strong anti-interference ability.

This module, you can use the built-in 78M05 take power by driving the power section, but in order to avoid damage to the regulator chip, when use is greater than the drive voltage of 12V, use an external 5V logic supply.

The module uses a large capacity filter capacitor, freewheeling diode protection, and can improve reliability.

This module integrates a built-in 5V power supply. When you drive voltage of 7V-35V can onboard 5V logic supply, do not input voltage when using onboard5V power supply, the +5 V power supply interface, but leads to 5V voltage for external use

When ENA so IN1 IN2 control OUT1 OUT2
When ENB so IN3 IN4 control OUT3 OUT4



ITEM INCLUDED:

1 x L298N Dual H-Bridge Stepper / DC Motor Driver Module

Contact us:
T (+63) 02 577 8214
M (GLOBE) (+63) 995 629 48 43
M (SMART) (+63) 949 966 59 73
Email: [email protected]
Facebook: EDW ElecDesignWorks
Website: www.elecdesignworks.com
Address: 2nd flr. CW Arcade Bldg., #20 Alcalde Jose St. Brgy Kapasigan Pasig City, Philippines 1600