L293D DIP SOP PUSH PULL FOUR CHANNEL MOTOR DRIVER IC

PRODUCT VIDEO:
https://www.facebook.com/PJtronixDavao/videos/vb.100008493253796/145076412188334 9/?type=3&theater

Condition: New
Contact #: 0998 971 6948
Facebook Page: PJtronix
Location: Davao City / We do Shipping / Meet-up Davao City Area


*Also accepts: Pre-ordering of items, 3D-Printing, Metal Works, Project Development for Thesis/Capstone/Product both Software and Hardware related to Arduino / Raspberry Pie / Visual Basic / C++ / AndroidApp /PC or Web Database

Description:
---> Run four solenoids, two DC motors or one bi-polar or uni-polar stepper with up to 600mA per channel using the L293D. These are perhaps better known as "the drivers in our Adafruit Motorshield". If you accidentally damaged the drivers in a shield, you can use one of these puppies to replace it. Or you can breadboard something on your own!

---> Each chip contains two full H-bridges (four half H-bridges). That means you can drive four solenoids, two DC motors bi-directionally, or one stepper motor. Just make sure theyre good for under 600 mA since thats the limit of this chip. They do handle a peak of 1.2A but thats just for a short amount of time. What we like most about this particular driver is that it comes with built in kick-back diodes internally so you dont have to worry about the inductive kick damaging your project or driver

---> Theres a PWM input per driver so you can control motor speed. Runs at 5V logic. Good for motor voltages from 4.5V up to 36V! This wont work well for 3V motors. The motor voltage is separate from the logic voltage.

Key Features:
---> 600mA Output Current Capability per channel
---> 1.2A Pea output current (non repetitive) per channel
---> Enable facility
---> Overtemperature protection
---> Logical "0" input voltage up to 1.5v(high noise immunity)
---> Internal clamp diodes